about     shop     contact         

Thursday, May 2, 2013

diy valentino inspired bracelet

This project was inspired from a Valentino raincoat a saw a few weeks ago.  I loved the clear vinyl! Reminds me of the 80's and something different.  If you can find a hole puncher, I can't remember where I grab this from, but I assume you can get it at your local craft store or hardware store. The project takes about 15 minutes to make.  Enjoy your new accessory. 
 
Material: 
- studs (purchased from esty)
- hammer
- scissors
- vinyl (got from Joanns)
- hole puncher
- measuring tape
- permanent market 
- magnetic clasp  (not pictured)
Step 1: measure and mark1/2 inch between studs
Step 2: punch holes in vinyl with hole puncher
Step 3: put bottom of the stud in vinyl (make sure to leave the first hole empty)
Step 4: put top of stud in the vinyl 
Step 5: hammer the back of the stud on a hard surface
Step 6: continue to put all the studs in the vinyl strip, leaving an extra hole on each end
Step 7: put the magnetic clasp on each side

logo olivia j

6 comments:

  1. What a great idea! I love the look! Thanks for posting!

    xoxo

    www.cakeandcouture.com

    ReplyDelete
  2. Good job! :) Love your DIY bracelet!
    www.styleofdarina.blogspot.com

    ReplyDelete
  3. omg this is SUCH an amazing idea! Well done girl xxxx

    http://rendersublime.blogspot.com.au/

    ReplyDelete
  4. Absolutely stunning! I'm going to share this post now! Very very cool x

    www.stateofshop.com

    ReplyDelete
  5. Hi Olivia! I stumbled across your blog. I love your diy's. I want to make a bracelet like this! So fun. Thanks for sharing.

    xx Love & Aloha
    http://elisharon.blogspot.com

    ReplyDelete

Thank you for your comments! Olivia